Every tap is tapered for the first few threads that help it to start the cutting process easier.Įach tap is marked with three distinct numbers: When you tap a hole, it creates female threads within the hole. There are grooves or valleys cut into the tap’s body. It has several flutes in its design and a higher number of flutes increase its strength. People use taps to cut threads for bolts or screws into materials such as plastic, metal, or even wood.Ī tap can remove material from a punched hole or a pre-drilled hole. The best thing about this tap is that it can cut threads all the way to the bottom of the hole. These taps are best used after the taper or plug tap has been used to cut the initial thread. It has only 1 or 1 tapered cutting edge before you engage the full cutting force. It is also a bit more aggressive than taper tap and typically has between 3 to 5 tapered threads at the tip.īottoming tap – this is the most aggressive top of them all. Plug tap – its cutting edges have a less pronounced taper and give it a bit less gradual cutting action than taper tap. This provides a less aggressive cutting action. There are almost 8 to 10 threads tapered from the tip. Taper tap – you can identify a taper tape by visible and pronounced tapering at the cutting edges. Let’s discuss a little about all of them. The three tap types are taper, plug, and bottoming tap. The threads just behind the cutting edge may be relieved or backed off to produce sharpness. The interruption between the threads and flutes creates the cutting edge. There may be two, three, or four flutes between the to cut screw threads in a hole or a nut.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |